- NetBSD Manual Pages
RUP(1) NetBSD General Commands Manual RUP(1)
Powered by man-cgi (2021-06-01).
Maintained for NetBSD
by Kimmo Suominen.
Based on man-cgi by Panagiotis Christias.
rup -- remote status display
rup [-dhlt] [host ...]
rup displays a summary of the current system status of a particular host
or all hosts on the local network. The output shows the current time of
day, how long the system has been up, and the load averages. The load
average numbers give the number of jobs in the run queue averaged over 1,
5 and 15 minutes.
The following options are available:
-d For each host, report what its local time is. This is useful for
checking time synchronization on a network.
-h Sort the display alphabetically by host name.
-l Sort the display by load average.
-t Sort the display by up time.
The rpc.rstatd(8) daemon must be running on the remote host for this com-
mand to work. rup uses an RPC protocol defined in
example% rup otherhost
otherhost up 6 days, 16:45, load average: 0.20, 0.23, 0.18
rup: RPC: Program not registered
The rpc.rstatd(8) daemon has not been started on the remote host.
rup: RPC: Timed out
A communication error occurred. Either the network is exces-
sively congested, or the rpc.rstatd(8) daemon has terminated on
the remote host.
rup: RPC: Port mapper failure - RPC: Timed out
The remote host is not running the portmapper (see rpcbind(8)),
and cannot accommodate any RPC-based services. The host may be
ruptime(1), rpc.rstatd(8), rpcbind(8)
The rup command appeared in SunOS.
NetBSD 9.99 June 7, 1993 NetBSD 9.99