- NetBSD Manual Pages
FSYNC(2) NetBSD System Calls Manual FSYNC(2)
Powered by man-cgi (2021-06-01).
Maintained for NetBSD
by Kimmo Suominen.
Based on man-cgi by Panagiotis Christias.
fsync, fsync_range -- synchronize a file's in-core state with that on
Standard C Library (libc, -lc)
fsync_range(int fd, int how, off_t start, off_t length);
fsync() causes all modified data and attributes of fd to be written to a
permanent storage device. This normally results in all in-core modified
copies of buffers for the associated file to be written to a disk.
fsync_range() is similar, but provides control over the region of the
file to be synchronized, and the method of synchronization.
These functions should be used by programs that require a file to be in a
known state, for example, in building a simple transaction facility.
Note that writing the data to a permanent storage device does not neces-
sarily write the data to permanent storage media within that device; for
example, after writing data to a disk device, the data might reside in a
cache within the device, but not yet on more permanent storage within the
device. Neither fsync() nor the default behavior of fsync_range() (with-
out the FDISKSYNC flag) will flush disk caches, because they assume that
storage devices are able to ensure that completed writes are transferred
to media some time between the write and a power failure or system crash.
fsync_range() causes all modified data starting at start for length
length of fd to be written to a permanent storage device. If the length
parameter is zero, fsync_range() will synchronize all of the file data.
fsync_range() takes a how parameter which contains one or more of the
FDATASYNC Synchronize the file data and sufficient meta-data to
retrieve the data for the specified range. This is
equivalent to fdatasync(2) on the specified range.
FFILESYNC Synchronize all modified file data and meta-data for the
specified range. This is equivalent to fsync(2) on the
FDISKSYNC Request the destination device to ensure that the rele-
vant data and meta-data is flushed from any cache to
permanent storage media. In the present implementation,
the entire cache on the affected device will be flushed,
and this may have a significant impact on performance.
The FDATASYNC and FFILESYNC flags are mutually exclusive. Either of
those flags may be combined with the FDISKSYNC flag.
Note that fsync_range() requires that the file fd must be open for writ-
ing, whereas fsync() does not.
A 0 value is returned on success. A -1 value indicates an error.
fsync() or fsync_range() fail if:
[EBADF] fd is not a valid descriptor.
[EINVAL] fd refers to a socket, not to a file.
[EIO] An I/O error occurred while reading from or writing to
the file system.
Additionally, fsync_range() fails if:
[EBADF] fd is not open for writing.
[EINVAL] start + length is less than start.
For optimal efficiency, the fsync_range() call requires that the file
system containing the file referenced by fd support partial synchroniza-
tion of file data. For file systems which do not support partial syn-
chronization, the entire file will be synchronized and the call will be
the equivalent of calling fsync().
fdatasync(2), sync(2), sync(8)
The fsync() function call appeared in 4.2BSD.
The fsync_range() function call first appeared in NetBSD 2.0 and is mod-
eled after the function available in AIX.
NetBSD 9.1 September 22, 2013 NetBSD 9.1