pipe(2) - NetBSD Manual Pages

Command: Section: Arch: Collection:  
PIPE(2)                   NetBSD Programmer's Manual                   PIPE(2)

pipe - create descriptor pair for interprocess communication
Standard C Library (libc, -lc)
#include <unistd.h> int pipe(int fildes[2]);
The pipe() function creates a pipe, which is an object allowing unidirec- tional data flow, and allocates a pair of file descriptors. The first descriptor connects to the read end of the pipe, and the second connects to the write end, so that data written to fildes[1] appears on (i.e., can be read from) fildes[0]. This allows the output of one program to be sent to another program: the source's standard output is set up to be the write end of the pipe, and the sink's standard input is set up to be the read end of the pipe. The pipe itself persists until all its associated descriptors are closed. A pipe whose read or write end has been closed is considered widowed. Writing on such a pipe causes the writing process to receive a SIGPIPE signal. Widowing a pipe is the only way to deliver end-of-file to a reader: after the reader consumes any buffered data, reading a widowed pipe returns a zero count.
On successful creation of the pipe, zero is returned. Otherwise, a value of -1 is returned and the variable errno set to indicate the error.
The pipe() call will fail if: [EMFILE] Too many descriptors are active. [ENFILE] The system file table is full. [EFAULT] The fildes buffer is in an invalid area of the process's address space. The reliable detection of this error cannot be guaranteed; when not detected, a signal may be delivered to the process, indicating an address violation.
sh(1), fork(2), read(2), socketpair(2), write(2)
The pipe() function conforms to IEEE Std 1003.1-1990 (``POSIX'').
A pipe() function call appeared in Version 6 AT&T UNIX. NetBSD 1.6.2 July 17, 1994 1
Powered by man-cgi (2024-03-20). Maintained for NetBSD by Kimmo Suominen. Based on man-cgi by Panagiotis Christias.