umcpmioctl(8) - NetBSD Manual Pages

Command:
Section:
Arch:
Collection:
>>>
UMCPMIOCTL(8)           NetBSD System Manager's Manual           UMCPMIOCTL(8)


NAME

     umcpmioctl -- interact with a MCP2221 / MCP2221A multi-io chip


SYNOPSIS

     umcpmioctl [-dh] device status
     umcpmioctl [-dh] device get sram
     umcpmioctl [-dh] device get gp
     umcpmioctl [-dh] device get flash cs
     umcpmioctl [-dh] device get flash gp
     umcpmioctl [-dh] device get flash usbman
     umcpmioctl [-dh] device get flash usbprod
     umcpmioctl [-dh] device get flash usbsn
     umcpmioctl [-dh] device get flash chipsn
     umcpmioctl [-dh] device put flash gp GPn PIN_FUNCTION ...


DESCRIPTION

     The umcpmioctl utility interacts with a MCP2221 / MCP2221A and can be
     used to pull the status of the chip, get the SRAM values, get the values
     from the on-board FLASH and can be used to set some of the FLASH values
     associated with the GPIO pins.  The values from flash are copied into the
     SRAM when the chip enumerates or powers up.

     For the put flash command, GPn is one of GP0, GP1, GP2 or GP3, and
     PIN_FUNCTION is one of GPIO_PIN_INPUT, GPIO_PIN_OUTPUT, GPIO_PIN_ALT0,
     GPIO_PIN_ALT1, GPIO_PIN_ALT2, GPIO_PIN_ALT3, DEFAULT_OUTPUT_ZERO or
     DEFAULT_OUTPUT_ONE.

     For the put flash command, the GPn and PIN_FUNCTION pairs may be
     repeated.


EXAMPLES

           umcpmioctl /dev/umcpmio0ctl status

     Query the chip for its status.

           umcpmioctl /dev/umcpmio0ctl get sram

     Return the values from the SRAM on the chip.

           umcpmioctl /dev/umcpmio0ctl get flash cs

     Return the values for the chip settings from the FLASH.

           umcpmioctl /dev/umcpmio0ctl put flash gp GP0 GPIO_PIN_INPUT

     This will set the GP0 pin to be an input pin on start up of the chip.

           umcpmioctl /dev/umcpmio0ctl put flash gp GP2 GPIO_PIN_OUTPUT GP0
           GPIO_PIN_ALT0

     This will set the GP2 pin to be an output pin and GP0 pin to have the
     ALT0 function upon chip start up.


SEE ALSO

     gpio(4), umcpmio(4)


HISTORY

     The umcpmioctl utility first appeared in NetBSD 11.0.


AUTHORS

     The umcpmioctl utility was written by Brad Spencer
     <brad@anduin.eldar.org>.


BUGS

     Only the gpio settings can be changed in FLASH.

     The output is not very pleasant to use and one will probably need to have
     the data sheet for the MCP2221 / MCP2221A on hand to make sense of it.

NetBSD 10.99                   November 24, 2024                  NetBSD 10.99