- NetBSD Manual Pages
RTQUERY(8) NetBSD System Manager's Manual RTQUERY(8)
Powered by man-cgi (2021-06-01).
Maintained for NetBSD
by Kimmo Suominen.
Based on man-cgi by Panagiotis Christias.
rtquery -- query routing daemons for their routing tables
rtquery [-1np] [-a secret] [-r addr] [-w timeout] host ...
rtquery [-t op] host ...
rtquery is used to query a RIP network routing daemon, routed(8) or
gated(8), for its routing table by sending a request or poll command.
The routing information in any routing response packets returned is dis-
played numerically and symbolically.
rtquery by default uses the request command. When the -p option is spec-
ified, rtquery uses the poll command, an undocumented extension to the
RIP protocol supported by gated(8). When querying gated(8), the poll
command is preferred over the request command because the response is not
subject to Split Horizon and/or Poisoned Reverse, and because some ver-
sions of gated do not answer the request command. routed(8) does not
answer the poll command, but recognizes requests coming from rtquery and
so answers completely.
rtquery is also used to turn tracing on or off in routed(8).
The following options are available:
-n displays only the numeric network and host numbers instead of
both numeric and symbolic.
-p uses the poll command to request full routing information from
gated(8). This is an undocumented extension RIP protocol sup-
ported only by gated(8).
-1 queries using RIP version 1 instead of RIP version 2.
changes the delay for an answer from each host. By default, each
host is given 15 seconds to respond.
asks about the route to destination addr.
causes the query to be sent with the indicated cleartext or MD5
-t op changes tracing, where op is one of the following. Requests from
processes not running with UID 0 or on distant networks are gen-
erally ignored by the daemon except for a message in the system
log. gated(8) is likely to ignore these debugging requests.
turns tracing on into the specified file. That file
must usually have been specified when the daemon was
started or be the same as a fixed name, often
more increases the debugging level.
off turns off tracing.
dump dumps the daemon's routing table to the current trace-
gated(8), routed(8), pkgsrc/net/gated
Routing Information Protocol, RIPv1, RFC 1058, 1988.
Routing Information Protocol, RIPv2, RFC 1723, 1994.
NetBSD 10.99 September 11, 2009 NetBSD 10.99