uuencode(5)
- NetBSD Manual Pages
UUENCODE(5) NetBSD File Formats Manual UUENCODE(5)
NAME
uuencode -- format of an encoded uuencode file
DESCRIPTION
Files output by uuencode(1) consist of a header line, followed by a num-
ber of body lines, and a trailer line. The uudecode(1) command will
ignore any lines preceding the header or following the trailer. Lines
preceding a header must not, of course, look like a header.
The header line starts with the word ``begin'', a space, a file mode (in
octal), a space, and finally a string which names the file being encoded.
The central engine of uuencode(1) is a six-bit encoding function which
outputs an ASCII character. The six bits to be encoded are treated as a
small integer and added with the ASCII value for the space character
(octal 40). The result is a printable ASCII character. In the case
where all six bits to be encoded are zero, the ASCII backquote character
` (octal 140) is emitted instead of what would normally be a space.
The body of an encoded file consists of one or more lines, each of which
may be a maximum of 86 characters long (including the trailing newline).
Each line represents an encoded chunk of data from the input file and
begins with a byte count, followed by encoded bytes, followed by a new-
line.
The byte count is a six-bit integer encoded with the above function, rep-
resenting the number of bytes encoded in the rest of the line. The
method used to encode the data expands its size by 133% (described
below). Therefore it is important to note that the byte count describes
the size of the chunk of data before it is encoded, not afterwards. The
six bit size of this number effectively limits the number of bytes that
can be encoded in each line to a maximum of 63. While uuencode(1) will
not encode more than 45 bytes per line, uudecode(1) will tolerate the
maximum line size.
The remaining characters in the line represent the data of the input file
encoded as follows. Input data are broken into groups of three eight-bit
bytes, which are then interpreted together as a 24-bit block. The first
bit of the block is the highest order bit of the first character, and the
last is the lowest order bit of the third character. This block is then
broken into four six-bit integers which are encoded one by one starting
from the first bit of the block. The result is a four character ASCII
string for every three bytes of input data.
Encoded lines of data continue in this manner until the input file is
exhausted. The end of the body is signaled by an encoded line with a
byte count of zero (the ASCII backquote character `).
Obviously, not every input file will be a multiple of three bytes in
size. In these cases, uuencode(1) will pad the remaining one or two
bytes of data with null characters until a three byte group is created.
The byte count in a line containing null padding will reflect the actual
number of bytes encoded, making it possible to convey how many bytes are
null.
The trailer line consists of ``end'' on a line by itself.
SEE ALSO
mail(1), uudecode(1), uuencode(1), ascii(7)
HISTORY
The uuencode file format appeared in 4.0BSD.
BUGS
The interpretation of the uuencode format relies on properties of the
ASCII character set and may not work correctly on non-ASCII systems.
NetBSD 10.99 March 4, 2019 NetBSD 10.99
Powered by man-cgi (2024-03-20).
Maintained for NetBSD
by Kimmo Suominen.
Based on man-cgi by Panagiotis Christias.