autoconf(4) - NetBSD Manual Pages

Command: Section: Arch: Collection:  
AUTOCONF(4)          NetBSD/amiga Kernel Interfaces Manual         AUTOCONF(4)

autoconf -- diagnostics from the autoconfiguration code
When NetBSD bootstraps it probes the innards of the machine on which it is running and locates controllers, drives, and other devices, printing out what it finds on the console. This procedure is driven by a system configuration table which is processed by config(1) and compiled into each kernel. Devices which exist in the machine but are not configured into the kernel are not detected.
CPU class not configured. You tried to boot NetBSD on a class of CPU type which it doesn't (or at least this compiled version of NetBSD doesn't) understand. %s at mainbus0. An Amiga internal device `%s' was configured not configured. If this line follows the `fd0 at fdc0' configuration line, this diagnostic indicates that a second floppy drive was detected, but was not configured into the kernel. zbus0 at mainbus0 [mem 0x%x-0x%x]. The kernel is configuring AutoConfig- ured expansion boards. If any Zorro II memory was detected, the virtual address of the space reserved for DMA bounce buffers is printed. %s at zbus0: pa 0x%x man/prod %d/%d. A Zorro expansion board was config- ured. `pa 0x%0x' is the physical address the board was configured at. `Man/prod %d/%d' is the manufacturer/product codes. %s at zbus0: pa 0x%x man/prod %d/%d not configured. A Zorro expansion board located at `pa 0x%0x' with a manufacturer/product code `%d/%d' was found that is not configured into the kernel.
config(1), amiga/intro(4), boot(8) NetBSD 10.99 February 17, 2017 NetBSD 10.99
Powered by man-cgi (2024-03-20). Maintained for NetBSD by Kimmo Suominen. Based on man-cgi by Panagiotis Christias.