ESP(4) NetBSD Kernel Interfaces Manual ESP(4)
NAME
esp -- NCR 53C9x, Emulex ESP406, and Qlogic FAS408 SCSI driver
SYNOPSIS
ISA bus esp0 at isa? port 0x230 irq ? PCMCIA esp* at pcmcia? function ? MCA esp* at mca? slot ? mac68k esp0 at obio? esp1 at obio? macppc esp0 at obio0 flags 0x00ff sun3x esp0 at obio0 addr 0x66000000 ipl 2 flags 0xff0f sparc dma0 at obio0 addr 0xfa001000 level 4 (Sun 4/300) esp0 at obio0 addr 0xfa000000 level 4 (Sun 4/300) dma0 at sbus0 slot ? offset ? (sun4c and sun4m) esp0 at sbus0 slot ? offset ? (sun4c) esp0 at dma0 (sun4m) dma* at sbus? slot ? offset ? (Sbus) esp* at sbus? slot ? offset ? (SBus, older PROMs) esp* at dma? (SBus) scsibus* at esp?
DESCRIPTION
The esp driver provides support for the NCR 53C90, 53C94 and 53C96; Emulex ESP100, ESP100A, ESP200 and ESP406; and Qlogic FAS216 and FAS408 SCSI controller chips found in a wide variety of systems and peripheral boards. This includes the Qlogic ISA and VLB SCSI host adapters, and the Sun Fast SCSI buffered Ethernet for Sbus (FSBE/S, X1053A, Sun part # 501-2015). For Qlogic PCI SCSI host adapters, use the isp(4) device.
CONFIGURATION
The esp driver supports the following flags for use in config(1) files: bits 0-7: disable disconnect/reselect for the corresponding SCSI tar- get bits 8-15: disable synchronous negotiation for the corresponding SCSI target bits 16-23: disable tagged queuing for the corresponding SCSI target "Target" is synonymous with SCSI ID number. Note that SCSI tape drives should be allowed to perform disconnect/rese- lect or performance will suffer.
SEE ALSO
cd(4), ch(4), intro(4), le(4), mca(4), pcmcia(4), scsi(4), sd(4), ss(4), st(4), uk(4) NetBSD 9.3 December 3, 2001 NetBSD 9.3
Powered by man-cgi (2024-08-26). Maintained for NetBSD by Kimmo Suominen. Based on man-cgi by Panagiotis Christias.