- NetBSD Manual Pages
AUE(4) NetBSD Kernel Interfaces Manual AUE(4)
Powered by man-cgi (2021-06-01).
Maintained for NetBSD
by Kimmo Suominen.
Based on man-cgi by Panagiotis Christias.
aue -- ADMtek AN986 and AN8511 Pegasus USB Ethernet driver
aue* at uhub?
ukphy* at mii?
The aue driver supports the following adapters:
@Home USB 10/100
Billionton Systems USB100
Corega FEther USB-TX
Corega FEther USB-TXS
I/O DATA USB ET/TX
I/O DATA USB ET/TXS
I/O DATA ETX-US2
Melco Inc. LU-ATX
The aue driver provides support for USB Ethernet adapters based on the
ADMtek AN986 Pegasus and AN8511 Pegasus II chipsets.
The Pegasus contains a 10/100 Ethernet MAC with MII interface and is
designed to work with both Ethernet and HomePNA transceivers. Although
designed to interface with 100Mbps peripherals, the existing USB standard
specifies a maximum transfer speed of 12Mbps. Users should therefore not
expect to actually achieve 100Mbps speeds with these devices.
The Pegasus supports a 64-bit multicast hash table, single perfect filter
entry for the station address and promiscuous mode. Packets are received
and transmitted over separate USB bulk transfer endpoints.
The aue driver supports the following media types:
autoselect Enable automatic selection of the media type and
options. The user can manually override the auto-
matically selected mode by adding media options to
the /etc/rc.conf file.
10baseT/UTP Set 10Mbps operation. The mediaopt option can also
be used to enable full-duplex operation. Not spec-
ifying full duplex implies half-duplex mode.
100baseTX Set 100Mbps (fast Ethernet) operation. The
mediaopt option can also be used to enable
full-duplex operation. Not specifying full duplex
implies half-duplex mode.
The aue driver supports the following media options:
full-duplex Force full duplex operation. The interface will
operate in half duplex mode if this media option is
For more information on configuring this device, see ifconfig(8).
aue%d: watchdog timeout A packet was queued for transmission and a
transmit command was issued, however the device failed to acknowledge the
transmission before a timeout expired.
aue%d: no memory for rx list The driver failed to allocate an mbuf for
the receiver ring.
arp(4), netintro(4), usb(4), ifconfig(8)
ADMtek AN986 data sheet, http://www.admtek.com.tw.
The aue device driver first appeared in FreeBSD 4.0, and in NetBSD 1.5.
The aue driver was written by Bill Paul <firstname.lastname@example.org>.
NetBSD 9.3 September 25, 2010 NetBSD 9.3