intro(4)
- NetBSD Manual Pages
INTRO(4) NetBSD/hppa Kernel Interfaces Manual INTRO(4)
NAME
intro -- introduction to special files and hardware support
DESCRIPTION
This section describes the special files, related driver functions, and
networking support available in the system. In this part of the manual,
the SYNOPSIS section of each configurable device gives a sample specifi-
cation for use in constructing a system description for the config(1)
program. The DIAGNOSTICS section lists messages which may appear on the
console and/or in the system error log /var/log/messages due to errors in
device operation; see syslogd(8) for more information.
This section contains both devices which may be configured into the sys-
tem and network related information. The networking support is intro-
duced in netintro(4).
DEVICE SUPPORT
This section describes the hardware supported on the HP PA-RISC platform.
Software support for these devices comes in two forms. A hardware device
may be supported with a character or block device driver, or it may be
used within the networking subsystem and have a network interface driver.
Character and block devices are accessed through files in the file system
of a special type; see mknod(8). Network interfaces are indirectly
accessed through the interprocess communication facilities provided by
the system; see socket(2).
A hardware device is identified to the system at configuration time and
the appropriate device or network interface driver is then compiled into
the system. When the resultant system is booted, the autoconfiguration
facilities in the system probe for the device and, if found, enable the
software support for it. If a device does not respond at autoconfigura-
tion time it is not accessible at any time afterwards. To enable a
device which did not autoconfigure, the system must be rebooted.
The autoconfiguration system is described in autoconf(4).
SUPPORTED SYSTEMS
NetBSD hppa should run on systems similar to those, listed below, as long
as they're based upon the following:
· HP PA-RISC 1.1 processors:
PA7000
PA7100/PA7150
PA7200/PA7250
PA7100LC
PA7300LC
· Viper memory controller;
· GSC bus controllers:
ASP
LASI Super-integrated I/O
WAX Basic I/O
· SCSI I/O-processors:
NCR53c700/710 Narrow Single-Ended
NCR53c720 Fast Wide Differential
· Intel i82596 CA/DX LAN coprocessors
· Venom, (H)CRX-8 and (H)CRX-24 video controllers
· EISA Adapters:
i82350 (Mongoose)
WAX-EISA
· PCI Adapters:
Dino GSC-PCI bridge
Cujo GSC-PCI 64bit bridge
· Human Interface Loop (HIL) keyboard and mouse
· PS/2 port keyboard and mouse
Below a list of HP 9000/700 models targetted for support is listed,
including basic system characteristics.
Model MHz CPU Caches, KB Expansion
705 35 7000 32/64 N/A
710 50 7000 32/64 N/A
720 50 7000 128/256 EISA, GSC
730 66 7000 128/256 EISA, GSC
750 66 7000 256/256 4 EISA, 2 SGC
715 33 7100 64/64 EISA/SGC
715 50 7100 64/64 EISA/SGC
715 75 7100 256/256 EISA/SGC
725 50 7100 64/64 3 EISA, EISA/SGC
725 75 7100 256/256 3 EISA, EISA/SGC
735 100 7100 256/256 EISA, SGC
742i 50 7100 64/64 N/A
745i 50 7100 64/64 4 EISA
745i 100 7100 256/256 4 EISA
747i 50 7100 64/64 2 EISA, SGC, 6 VME
747i 100 7100 256/256 2 EISA, SGC, 6 VME
755 100 7100 256/256 4 EISA, 2 SGC
735 125 7150 256/256 EISA, SGC
755 125 7150 256/256 4 EISA, 2 SGC
712 60 7100LC 32/32 GIO, TSIO
712 80 7100LC 128/128 GIO, TSIO
712 100 7100LC 128/128 GIO, TSIO
715 64 7100LC 128/128 EISA/GSC
715 80 7100LC 128/128 EISA/GSC
715 100 7100LC 128/128 EISA/GSC
715XC 100 7100LC 512/512 EISA/GSC
725 64 7100LC 128/128 EISA, 3 EISA/GSC
725 100 7100LC 128/128 EISA, 3 EISA/GSC
743i 64 7100LC 128/128 2 GSC-M/2(4), VME
743i 100 7100LC 128/128 2 GSC-M/2(4), VME
748i 64 7100LC 128/128 2 GSC-M/2(4), 4 EISA/PCI, 6 VME
748i 100 7100LC 128/128 2 GSC-M/2(4), 4 EISA/PCI, 6 VME
SAIC 60 7100LC 32/32 GIO, TSIO, 2 PCMCIA
SAIC 80 7100LC 128/128 GIO, TSIO, 2 PCMCIA
J200 100 7200 256/256 GSC, 2 EISA, 2 EISA/GSC
J210 120 7200 256/256 GSC, 2 EISA, 2 EISA/GSC
J210XC 120 7200 1MB/1MB GSC, 2 EISA, 2 EISA/GSC
C100 100 7200 256/256 GSC, 3 EISA/GSC
C110 120 7200 256/256 GSC, 3 EISA/GSC
744 132 7300LC 64/64 2 GSC-M/2(4), VME
744 165 7300LC 64/64+512 2 GSC-M/2(4), VME
745 132 7300LC 64/64 2 GSC-M/2(4), 4 EISA/PCI
745 165 7300LC 64/64+512 2 GSC-M/2(4), 4 EISA/PCI
748 132 7300LC 64/64 2 GSC-M/2(4), 4 EISA/PCI, 6 VME
748 165 7300LC 64/64+512 2 GSC-M/2(4), 4 EISA/PCI, 6 VME
A180 180 7300LC 64/64 2 HSC/PCI
A180C 180 7300LC 64/64+1MB 2 HSC/PCI
B132L 132 7300LC 64/64(+1MB) GSC/PCI, GSC/PCI/EISA
B132L+ 132 7300LC 64/64(+1MB) GSC/PCI, GSC/PCI/EISA
B160L 160 7300LC 64/64(+1MB) GSC/PCI, GSC/PCI/EISA
B180L+ 180 7300LC 64/64(+1MB) GSC/PCI, GSC/PCI/EISA
C132L 132 7300LC 64/64(+1MB) 2 GSC/PCI/EISA, 2 GSC/EISA
C160L 160 7300LC 64/64(+1MB) 2 GSC/PCI/EISA, 2 GSC/EISA
RDI 132 7300LC 64/64(+1MB) 2 CardBus
RDI 160 7300LC 64/64(+1MB) 2 CardBus
RDI 180 7300LC 64/64(+1MB) 2 CardBus
LIST OF DEVICES
The devices listed below are supported in this incarnation of the system.
Devices are indicated by their functional interface. Not all supported
devices are listed.
hppa/asp(4) The ASP I/O controller; found in most of the older machines
which don't have LASI or WAX. Includes GSC-bus controller,
to which most of the devices are attached. Most of I/O is
still on external chips though.
com(4) The RS-232 ports.
hppa/cpu(4) The Central Processor itself, makes sure the machine does
something useful.
tlp(4) DEC/Intel 21140, 21143, 21145 and clone 10/100 Ethernet con-
troller.
hppa/dino(4)
The pci(4) bridge on most of the newer systems.
hppa/harmony(4)
CS4215/AD1849 audio.
hil(4) Human Interface Loop, sporting several input devices, e.g.
keyboards, mice, tablets and such.
iee(4) i82596 CA/DX LAN controller. Found in every 700, either
included in the MBA or on an external chip on mainboard.
hppa/lasi(4)
LSI?, found in almost all HP 9000/700 workstations. Inte-
grates most of the bus and I/O functions into one chip.
lpt(4) The Centronics printer port.
hppa/mem(4) Memory files and memory controller.
mongoose(4) The eisa(4) bus controller on most of the older 700
machines.
oosiop(4) Symbios/NCR 53C700 SCSI I/O processor.
osiop(4) Symbios/NCR 53C710 SCSI I/O processor.
pdc(4) The PROM interface, allows to call the routines in the
machine's PROM for things like initial console output and
such.
siop(4) LSI/Symbios Logic/NCR 53C8xx SCSI I/O processor.
sti(4) The system graphics driver.
hppa/wax(4) The other reincarnation of hppa/lasi(4) used for cheap ASIC
implementations for add-on devices.
SEE ALSO
config(1), autoconf(4)
PA-RISC Information Resource: http://www.openpa.net/
HISTORY
The hppa intro first appeared with OpenBSD 2.0. It was ported to
NetBSD 2.0 by Jochen Kunz.
NetBSD 9.1 February 17, 2017 NetBSD 9.1
Powered by man-cgi (2021-06-01).
Maintained for NetBSD
by Kimmo Suominen.
Based on man-cgi by Panagiotis Christias.