harmony(4) - NetBSD Manual Pages

Command: Section: Arch: Collection:  
HARMONY(4)           NetBSD/hppa Kernel Interfaces Manual           HARMONY(4)

harmony -- CS4215/AD1849 audio interface
harmony* at gsc? audio* at harmony?
The harmony device uses the Crystal Semiconductor CS4215 16-Bit Multime- dia Audio Codec or Analog Devices AD1849 SoundPort(R) Stereo Codec chip to implement the audio device interface described in audio(4). This device is found on most HP PA-RISC workstations. The harmony has a maxi- mum precision of 16 bits and has a stereo input and stereo output. On HP 9000/712 models harmony also provides two additional channels for an add-on card with two fax/voice modems. One of the hardware registers reflects the state of the CHI bus that is used to communicate with the codec and thus being sampled at a low accu- racy secondary frequency (such as timeout(9)) produces poor quality ran- dom bit stream that is fed into the entropy pool of rnd(4).
An incomplete list of machines that feature harmony audio: 712/* 715/* 725/* 735/* 755/* B132L[+], B160L, B180L+ C100, C110, C132L, C160[L], C180, C200, C240, C360 J200, J210[XC], J280, J282, J2240
hppa/ioctl(2), audio(4), hppa/gsc(4), hppa/intro(4), rnd(4)
Support for harmony first appeared in OpenBSD 3.3. It was ported to NetBSD 1.6 by Chuck Silvers.
To trigger entropy collection CHI bus has to be programmed into the data mode that happens once a single buffer of data has been played or recorded. NetBSD 9.1 February 17, 2017 NetBSD 9.1
Powered by man-cgi (2024-03-20). Maintained for NetBSD by Kimmo Suominen. Based on man-cgi by Panagiotis Christias.