en(4) - NetBSD Manual Pages

Command: Section: Arch: Collection:  
EN(4)                 NetBSD/vax Kernel Interfaces Manual                EN(4)


NAME
en -- Xerox 3 Mb/s Ethernet interface
SYNOPSIS
en0 at uba0 csr 161000 vector enrint enxint encollide
DESCRIPTION
NOTE: This driver has not been ported from 4.4BSD yet. The en interface provides access to a 3 Mb/s Ethernet network. Due to limitations in the hardware, DMA transfers to and from the network must take place in the lower 64K bytes of the UNIBUS address space, and thus this must be among the first UNIBUS devices enabled after boot. Each of the host's network addresses is specified at boot time with an SIOCSIFADDR ioctl(2). The station address is discovered by probing the on-board Ethernet address register, and is used to verify the protocol addresses. No packets will be sent or accepted until a network address is supplied. The interface software implements an exponential backoff algorithm when notified of a collision on the cable. This algorithm uses a 16-bit mask and the VAX-11's interval timer in calculating a series of random backoff values. The algorithm is as follows: 1. Initialize the mask to be all 1's. 2. If the mask is zero, 16 retries have been made and we give up. 3. Shift the mask left one bit and formulate a backoff by masking the interval timer with the mask (this is actually the two's complement of the value). 4. Use the value calculated in step 3 to delay before retransmit- ting the packet.
DIAGNOSTICS
en%d: output error. The hardware indicated an error on the previous transmission. en%d: send error. After 16 retransmissions using the exponential backoff algorithm described above, the packet was dropped. en%d: input error. The hardware indicated an error in reading a packet off the cable. en%d: can't handle af%d. The interface was handed a message with addresses formatted in an unsuitable address family; the packet was dropped.
SEE ALSO
inet(4), netintro(4)
HISTORY
The en driver appeared in 4.2BSD.
BUGS
The device has insufficient buffering to handle back to back packets. This makes use in a production environment painful. The hardware does word at a time DMA without byte swapping. To compen- sate, byte swapping of user data must either be done by the user or by the system. A kludge to byte swap only IP packets is provided if the ENF_SWABIPS flag is defined in the driver and set at boot time with an SIOCSIFFLAGS ioctl(2). NetBSD 9.0 February 5, 2019 NetBSD 9.0
Powered by man-cgi (2024-03-20). Maintained for NetBSD by Kimmo Suominen. Based on man-cgi by Panagiotis Christias.