irdaattach(8) - NetBSD Manual Pages

Command:
Section:
Arch:
Collection:
>>>
IRDAATTACH(8)           NetBSD System Manager's Manual           IRDAATTACH(8)


NAME

     irdaattach -- attach serial lines to IrDA frame driver


SYNOPSIS

     irdaattach [-d dongle] [-fHhlmnp] ttyname


DESCRIPTION

     irdaattach is used to assign a tty line to an IrDA frame level driver.
     The following operands are supported by irdaattach:

     -d dongle     Sets the dongle type.  The following dongles are supported:

                   none      No dongle

                   tekram    Tekram IR-210B

                   jeteye    Extended Systems JetEye

                   actisys   ACTiSYS IR-220L

                   actisys+  ACTiSYS IR-220L+

                   litelink  Parallax LiteLink

                   girbil    Greenwich GIrBIL

                   The default is none.

     -f            Print the name of the IrDA frame device that should be used
                   to access the frames.

     -H            Turn on DTR/CTS flow control.  By default, no flow control
                   is done.

     -h            Turn on RTS/CTS flow control.  By default, no flow control
                   is done.

     -l            Turn on the CLOCAL flag, making it possible to run SLIP on
                   a cable without modem control signals (e.g. DTR, DSR, DCD).

     -m            Maintain modem control signals after closing the line.
                   Specifically, this disables HUPCL.

     -n            Do not detach from invoking tty.

     -p            Print process id to file.

     ttyname       Specifies the name of the tty device.  Ttyname should be a
                   string of the form `ttyXX', or `/dev/ttyXX'.

     Only the super-user may attach a network interface.

     The frame driver is detached by killing the irdaattach process.


EXAMPLES

           irdaattach tty00
           ircomm -Y -d `irdaattach -p -f /dev/tty02`


DIAGNOSTICS

     Messages indicating that the specified interface does not exist, the
     requested address is unknown, or that the user is not privileged but
     tried to alter an interface's configuration.


SEE ALSO

     daemon(3), irframe(4), irframetty(4), slattach(8)


HISTORY

     The irdaattach command appeared in NetBSD 1.6.

NetBSD 8.2                     December 4, 2001                     NetBSD 8.2