- NetBSD Manual Pages
RLOGIN(1) NetBSD General Commands Manual RLOGIN(1)
Powered by man-cgi (2020-09-24).
Maintained for NetBSD
by Kimmo Suominen.
Based on man-cgi by Panagiotis Christias.
rlogin -- remote login
rlogin [-468dEn] [-e char] [-l username] [-p port] host
rlogin [-468dEn] [-e char] [-p port] username@host
rlogin starts a terminal session on a remote host host.
rlogin first attempts to use the standard Berkeley rhosts authorization
mechanism. The options are as follows:
-4 Use IPv4 addresses only.
-6 Use IPv6 addresses only.
-8 The -8 option allows an eight-bit input data path at all
times; otherwise parity bits are stripped except when the
remote side's stop and start characters are other than
-d The -d option turns on socket debugging (see setsockopt(2))
on the TCP sockets used for communication with the remote
-E The -E option stops any character from being recognized as
an escape character. When used with the -8 option, this
provides a completely transparent connection.
-e char The -e option allows user specification of the escape char-
acter, which is ``~'' by default. This specification may
be as a literal character, or as an octal value in the form
-l username the -l option specifies an alternate username for the
remote login. If this option is not specified, your local
username will be used.
-n Set the TCP_NODELAY socket option, which can improve inter-
active responsiveness at the possible downside of increased
-p port Uses the given port instead of the one assigned to the ser-
vice ``login''. May be given either as symbolic name or as
A line of the form ``<escape char>.'' disconnects from the remote host.
Similarly, the line ``<escape char>^Z'' will suspend the rlogin session,
and ``<escape char><delayed-suspend char>'' suspends the send portion of
the rlogin, but allows output from the remote system. By default, the
tilde (``~'') character is the escape character, and normally control-Y
(``^Y'') is the delayed-suspend character.
All echoing takes place at the remote site, so that (except for delays)
the rlogin is transparent. Flow control via ^S/^Q and flushing of input
and output on interrupts are handled properly.
The following environment variable is used by rlogin:
TERM Determines the user's terminal type.
rcmd(1), rsh(1), rcmd(3), hosts.equiv(5), rhosts(5), environ(7)
The rlogin command appeared in 4.2BSD.
More of the environment should be propagated.
NetBSD 8.0 March 2, 2013 NetBSD 8.0