- NetBSD Manual Pages
IRDAATTACH(8) NetBSD System Manager's Manual IRDAATTACH(8)
Powered by man-cgi (2021-06-01).
Maintained for NetBSD
by Kimmo Suominen.
Based on man-cgi by Panagiotis Christias.
irdaattach -- attach serial lines to IrDA frame driver
irdaattach [-d dongle] [-fHhlmnp] ttyname
irdaattach is used to assign a tty line to an IrDA frame level driver.
The following operands are supported by irdaattach:
-d dongle Sets the dongle type. The following dongles are supported:
none No dongle
tekram Tekram IR-210B
jeteye Extended Systems JetEye
actisys ACTiSYS IR-220L
actisys+ ACTiSYS IR-220L+
litelink Parallax LiteLink
girbil Greenwich GIrBIL
The default is none.
-f Print the name of the IrDA frame device that should be used
to access the frames.
-H Turn on DTR/CTS flow control. By default, no flow control
-h Turn on RTS/CTS flow control. By default, no flow control
-l Turn on the CLOCAL flag, making it possible to run SLIP on
a cable without modem control signals (e.g. DTR, DSR, DCD).
-m Maintain modem control signals after closing the line.
Specifically, this disables HUPCL.
-n Do not detach from invoking tty.
-p Print process id to file.
ttyname Specifies the name of the tty device. Ttyname should be a
string of the form `ttyXX', or `/dev/ttyXX'.
Only the super-user may attach a network interface.
The frame driver is detached by killing the irdaattach process.
ircomm -Y -d `irdaattach -p -f /dev/tty02`
Messages indicating that the specified interface does not exist, the
requested address is unknown, or that the user is not privileged but
tried to alter an interface's configuration.
daemon(3), irframe(4), irframetty(4), slattach(8)
The irdaattach command appeared in NetBSD 1.6.
NetBSD 8.0 December 4, 2001 NetBSD 8.0