blacklistctl(8) - NetBSD Manual Pages

Command:
Section:
Arch:
Collection:
>>>
BLACKLISTCTL(8)         NetBSD System Manager's Manual         BLACKLISTCTL(8)


NAME

     blacklistctl -- display and change the state of blacklistd


SYNOPSIS

     blacklistctl dump [-abdnrw]


DESCRIPTION

     blacklistctl is a program used to display the state of blacklistd(8)

     The following options are available:

     -a      Show all database entries, by default it shows only the embryonic
             ones.

     -b      Show only the blocked entries.

     -d      Increase debugging level.

     -n      Don't display a header.

     -r      Show the remaining blocked time instead of the last activity
             time.

     -w      Normally the width of addresses is good for IPv4, the -w flag,
             makes the display wide enough for IPv6 addresses.


SEE ALSO

     blacklistd(8)


NOTES

     Sometimes the reported number of failed attempts can exceed the number of
     attempts that blacklistd(8) is configured to block.  This can happen
     either because the rule has been removed manually, or because there were
     more attempts in flight while the rule block was being added.  This con-
     dition is normal; in that case blacklistd(8) will first attempt to remove
     the existing rule, and then it will re-add it to make sure that there is
     only one rule active.


HISTORY

     blacklistctl appeared in NetBSD 7.


AUTHORS

     Christos Zoulas

NetBSD 7.1                      April 29, 2015                      NetBSD 7.1