- NetBSD Manual Pages
RAY(4) NetBSD Kernel Interfaces Manual RAY(4)
Powered by man-cgi (2021-06-01).
Maintained for NetBSD
by Kimmo Suominen.
Based on man-cgi by Panagiotis Christias.
ray -- Raytheon Raylink / WebGear Aviator IEEE 802.11 2Mbps Wireless
ray* at pcmcia? function ?
The ray device driver supports the Raytheon Raylink and Aviator 2.4/PRO
802.11 FH 2Mbps wireless PCMCIA cards. The cards can be operated in
either ad-hoc or infrastructure modes. The operating mode is selectable
with ifconfig(8) through a media option.
To communicate with other 802.11 cards a common network id or NWID must
be specified on each station that wishes to participate in the shared
wireless network. The NWID can be set with ifconfig(8).
The device uses IEEE 802.11 standard Frequency Hopping Spread Spectrum
signaling and operates in the ranges of 2.400 to 2.4835 Gigahertz. This
frequency range is further restricted by country according to that coun-
try's regulations. Currently the ray driver defaults to using the ranges
appropriate for the USA. To change this setting you must define the ker-
nel option RAY_PID_COUNTRY_CODE_DEFAULT to one of the following values:
The output power of the transceiver is 100mW and the card's power con-
sumption is 365 mA @ 5 volts. The transmission range in open air (line
of sight) is a maximum of 1000 feet (or ~304 meters), and indoors (i.e.,
with obstructions) it is a maximum of 500 feet (152 meters).
Cards supported by the ray driver include:
WebGear Aviator 2.4
WebGear Aviator PRO
Raytheon Raylink WLAN
ray0: card failed self test: status x Indicates the card has failed its
initial startup tests.
ifmedia(4), intro(4), pcmcia(4), ifconfig(8)
The ray driver first appeared in NetBSD 1.5.
The ray driver was written by Christian E. Hopps <chopps@NetBSD.org>.
Currently the infrastructure mode is untested, and authentication using
WEP is unimplemented.
NetBSD 7.1.2 January 24, 2000 NetBSD 7.1.2