aue(4) - NetBSD Manual Pages

Command:
Section:
Arch:
Collection:
>>>
AUE(4)                  NetBSD Kernel Interfaces Manual                 AUE(4)


NAME

     aue -- ADMtek AN986 and AN8511 Pegasus USB Ethernet driver


SYNOPSIS

     aue*   at uhub?
     ukphy* at mii?


HARDWARE

     The aue driver supports the following adapters:

           @Home USB 10/100
           Abocom DSB650TX
           Billionton Systems USB100
           Compaq HNE-200
           Corega FEther USB-TX
           Corega FEther USB-TXS
           D-Link DSB-650
           D-Link DSB-650TX
           D-Link DSB-650TX-PNA
           I/O DATA USB ETTX
           Hawking UF100
           Kingston KNU101TX
           LinkSys USB100TX
           LinkSys USB100H1
           LinkSys USB10TA
           Melco Inc. LU-ATX
           Microsoft MN110
           SOHOware NUB100
           SMC 2202USB
           SMC 2206USB/ETH


DESCRIPTION

     The aue driver provides support for USB Ethernet adapters based on the
     ADMtek AN986 Pegasus and AN8511 Pegasus II chipsets.

     The Pegasus contains a 10/100 Ethernet MAC with MII interface and is
     designed to work with both Ethernet and HomePNA transceivers.  Although
     designed to interface with 100Mbps peripherals, the existing USB standard
     specifies a maximum transfer speed of 12Mbps.  Users should therefore not
     expect to actually achieve 100Mbps speeds with these devices.

     The Pegasus supports a 64-bit multicast hash table, single perfect filter
     entry for the station address and promiscuous mode.  Packets are received
     and transmitted over separate USB bulk transfer endpoints.

     The aue driver supports the following media types:

     autoselect            Enable automatic selection of the media type and
                           options.  The user can manually override the auto-
                           matically selected mode by adding media options to
                           the /etc/rc.conf file.

     10baseT/UTP           Set 10Mbps operation.  The mediaopt option can also
                           be used to enable full-duplex operation.  Not spec-
                           ifying full duplex implies half-duplex mode.

     100baseTX             Set 100Mbps (fast Ethernet) operation.  The
                           mediaopt option can also be used to enable
                           full-duplex operation.  Not specifying full duplex
                           implies half-duplex mode.

     The aue driver supports the following media options:

     full-duplex           Force full duplex operation.  The interface will
                           operate in half duplex mode if this media option is
                           not specified.

     For more information on configuring this device, see ifconfig(8).


DIAGNOSTICS

     aue%d: watchdog timeout  A packet was queued for transmission and a
     transmit command was issued, however the device failed to acknowledge the
     transmission before a timeout expired.

     aue%d: no memory for rx list  The driver failed to allocate an mbuf for
     the receiver ring.


SEE ALSO

     arp(4), netintro(4), usb(4), ifconfig(8)

     ADMtek AN986 data sheet, http://www.admtek.com.tw.


HISTORY

     The aue device driver first appeared in FreeBSD 4.0, and in NetBSD 1.5.


AUTHORS

     The aue driver was written by Bill Paul <wpaul@ee.columbia.edu>.

NetBSD 5.2                      January 5, 2004                     NetBSD 5.2