RL(4) NetBSD/vax Kernel Interfaces Manual RL(4)
NAME
rl -- RL11/ RL01 and RL02 disk interface
SYNOPSIS
rlc0 at uba? csr 0177440 rl0 at rlc0 drive 0 rl* at rlc? drive ?
DESCRIPTION
The rl driver is a typical block-device disk driver; block device I/O is described in physio(4). The script MAKEDEV(8) should be used to create the special files; if a special file needs to be created by hand consult mknod(8).
FILES
/dev/rl[0-7][a-h] block files /dev/rrl[0-7][a-h] raw files
DIAGNOSTICS
rl%d: operation incomplete The current command to the disk did not com- plete within the timeout period. This may be due to hardware failure or a heavily loaded UNIBUS. rl%d: read data CRC The controller detected a CRC error on data read from the disk. Probably a bad disk pack. rl%d: header CRC The controller detected a CRC error on header data read from the disk. Probably a bad disk pack. rl%d: data late The controller was not able to transfer data over the bus fast enough to not overflow/underflow the internal FIFO, probably because a heavily loaded UNIBUS or mis-ordered UNIBUS devices. rl%d: header not found The requested sector was not found before the timer expired. If this error is the only error then it may indicate a software bug. rl%d: non-existent memory The controller tried to do DMA to/from a non- mapped address. This is a software bug. rl%d: memory parity error The host memory data sent had a parity error. This is a hardware failure.
SEE ALSO
hp(4), uda(4), up(4), syslogd(8)
HISTORY
The rl driver has been around nearly forever. A complete new rl driver showed up in NetBSD 1.5.
BUGS
Error handling is less than optimal. Seeks should be interleaved between multiple disks. NetBSD 5.1.2 April 22, 2000 NetBSD 5.1.2
Powered by man-cgi (2024-08-26). Maintained for NetBSD by Kimmo Suominen. Based on man-cgi by Panagiotis Christias.