getitimer(2) - NetBSD Manual Pages

Command: Section: Arch: Collection:  
GETITIMER(2)              NetBSD System Calls Manual              GETITIMER(2)

getitimer, setitimer -- get/set value of interval timer
Standard C Library (libc, -lc)
#include <sys/time.h> #define ITIMER_REAL 0 #define ITIMER_VIRTUAL 1 #define ITIMER_PROF 2 int getitimer(int which, struct itimerval *value); int setitimer(int which, const struct itimerval * restrict value, struct itimerval * restrict ovalue);
The system provides each process with three interval timers, defined in <sys/time.h>. The getitimer() call returns the current value for the timer specified in which in the structure at value. The setitimer() call sets a timer to the specified value (returning the previous value of the timer if ovalue is non-nil). A timer value is defined by the itimerval structure: struct itimerval { struct timeval it_interval; /* timer interval */ struct timeval it_value; /* current value */ }; If it_value is non-zero, it indicates the time to the next timer expira- tion. If it_interval is non-zero, it specifies a value to be used in reloading it_value when the timer expires. Setting it_value to 0 dis- ables a timer. Setting it_interval to 0 causes a timer to be disabled after its next expiration (assuming it_value is non-zero). Time values smaller than the resolution of the system clock are rounded up to this resolution (typically 10 milliseconds). The ITIMER_REAL timer decrements in real time. A SIGALRM signal is delivered when this timer expires. The ITIMER_VIRTUAL timer decrements in process virtual time. It runs only when the process is executing. A SIGVTALRM signal is delivered when it expires. The ITIMER_PROF timer decrements both in process virtual time and when the system is running on behalf of the process. It is designed to be used by interpreters in statistically profiling the execution of inter- preted programs. Each time the ITIMER_PROF timer expires, the SIGPROF signal is delivered. Because this signal may interrupt in-progress sys- tem calls, programs using this timer must be prepared to restart inter- rupted system calls.
Macros for manipulating time values are defined in <sys/time.h>. timerclear() sets a time value to zero, timerisset() tests if a time value is non-zero, timercmp() compares two time values, timeradd() adds a time value to another time value, timersub() computes the time difference between two time values.
If the calls succeed, a value of 0 is returned. If an error occurs, the value -1 is returned, and a more precise error code is placed in the global variable errno.
getitimer() and setitimer() will fail if: [EFAULT] The value parameter specified a bad address. [EINVAL] A value parameter specified a time that was too large to be handled.
gettimeofday(2), poll(2), select(2), sigaction(2)
The getitimer() function call appeared in 4.2BSD. NetBSD 5.0.1 August 14, 2004 NetBSD 5.0.1
Powered by man-cgi (2024-03-20). Maintained for NetBSD by Kimmo Suominen. Based on man-cgi by Panagiotis Christias.