moptrace(1) - NetBSD Manual Pages

Command: Section: Arch: Collection:  
MOPTRACE(1)             NetBSD General Commands Manual             MOPTRACE(1)


NAME
moptrace -- MOP Trace Utility
SYNOPSIS
moptrace [-a] [-d] [-3 | -4] moptrace [-d] [-3 | -4] [interface]
DESCRIPTION
moptrace prints the contents of MOP packages on the Ethernet connected to interface or all known interfaces if `-a' is given.
OPTIONS
-a Listen on all the Ethernets attached to the system. If `-a' is omitted, an interface must be specified. -d Run in debug mode, with all the output to stderr. -3 Ignore MOP V3 messages (Ethernet II). -4 Ignore MOP V4 messages (Ethernet 802.3).
SEE ALSO
mopchk(1), mopcopy(1), mopprobe(1), mopd(8) DECnet Digital Network Architecture Phase IV, Maintenance Operations Functional Specification V3.0.0, AA-X436A-TK. DECnet Digital Network Architecture, Maintenance Operations Protocol Functional Specification V4.0.0, EK-DNA11-FS-001.
AUTHORS
Mats O Jansson <moj@stacken.kth.se> NetBSD 4.0 October 2, 1995 NetBSD 4.0
Powered by man-cgi (2024-03-20). Maintained for NetBSD by Kimmo Suominen. Based on man-cgi by Panagiotis Christias.