lmcctl(8) - NetBSD Manual Pages

Command:
Section:
Arch:
Collection:
>>>
LMCCTL(8)               NetBSD System Manager's Manual               LMCCTL(8)


NAME

     lmcctl -- configuration utility for Lan Media SSI, HSSI, and DS3 cards


SYNOPSIS

     lmcctl [-i interface] [-l speed] [-cCeEkKsSoO]


DESCRIPTION

     lmcctl is the user-land control program for the Lan Media SSI, HSSI, and
     DS3 network interfaces.  The SSI is the LMC1000, and runs at various
     speeds up to 10Mbps.  The DS3 is the LMC5245 and runs at a speed of
     45Mbps.  The HSSI is the LMC5200, and has no internal clock generator.
     lmcctl is used to configure various media and protocol options dealing
     with HDLC serial links and hardware configurations.

     When no change is specified on the command line, the interface status is
     displayed.

     The command-line options for lmcctl are as follows:

     -i interface
             Use the specified interface name rather than the default of lmc0.

     -l speed
             (SSI card only) Set the interface to use a clock speed of speed.
             This is only used if the clock source is set to internal clock-
             ing.

     -c      (SSI, HSSI) Set the interface to use external clocking.  This is
             the default.

     -C      (SSI, HSSI) Set the interface to use internal clocking.  On the
             SSI card this uses the internal baud rate generator.  On the HSSI
             card it uses the PCI bus clock.

     -e      Select 16-bit CRC.  This is the default.

     -E      Select 32-bit CRC

     -k      Enable Cisco HDLC keepalive protocol.  This is the default.

     -K      Disable Cisco HDLC keepalive protocol.

     -s      (DS3) Disable the DS3 scrambler function.  This is the default.

     -S      (DS3) Enable the DS3 scrambler function.

     -o      (DS3) Program the card for cable lengths of less than 100 feet.
             In this mode, the card uses lower power to transmit data for
             short cable runs, which might otherwise overdrive a receiver.
             This is the default, and will work in most situations even with
             runs more than 100 feet.

     -O      (DS3) Program the card for cable lengths greater than 100 feet.


EXAMPLES

     To set a SSI card for a speed of 2048000 bits/sec with HDLC keepalive
     off, one could use:

           lmcctl -i lmc0 -l 2048000 -K


SEE ALSO

     ifconfig(8)


HISTORY

     The lmcctl program first appeared in NetBSD 1.4.


COPYRIGHT

     Copyright (c) 1997-1999 LAN Media Corporation (LMC)
     All rights reserved.  www.lanmedia.com

NetBSD 3.1.1                    April 16, 1999                    NetBSD 3.1.1