slattach(8) - NetBSD Manual Pages

Command: Section: Arch: Collection:  
SLATTACH(8)             NetBSD System Manager's Manual             SLATTACH(8)

slattach -- attach serial lines as network interfaces
slattach [-Hhlmn] [-s baudrate] [-t ldisc] ttyname
slattach is used to assign a tty line to a network interface which uses asynchronous serial lines. Currently the slattach command is used to attach sl(4) interfaces. These interfaces have to be created using the ifconfig(8). The resulting point-to-point link is not a broadcast interface and normally has a net- mask of create subcommand before the slattach command. The network source and destination addresses and other interface parame- ters are configured via ifconfig(8). The following operands are supported by slattach: -H Turn on DTR/CTS flow control. By default, no flow control is done. -h Turn on RTS/CTS flow control. By default, no flow control is done. -l Turn on the CLOCAL flag, making it possible to run SLIP on a cable without modem control signals (e.g. DTR, DSR, DCD). -m Maintain modem control signals after closing the line. Specifically, this disables HUPCL. -n Don't detach from invoking tty. -s baudrate Specifies the speed of the connection. If not specified, the default of 9600 is used. -t ldisc Specifies the line discipline to use for the tty. Sup- ported line disciplines are ``slip'' (creates a sl(4) instance). If this option is not specified, the default is ``slip''. This option is retained for backwards compati- bility with existing scripts. ttyname Specifies the name of the tty device. ttyname should be a string of the form `ttyXX', or `/dev/ttyXX'. Only the super-user may attach a network interface. To detach the interface, use ``ifconfig interface-name down'' after killing off the slattach process. Interface-name is the name that is shown by netstat(1).
Lock, initialize, and attach a line (on both sides): cu -t -F [hard|soft] -l /dev/dty00 ifconfig sl0 create slattach -l -t slip /dev/dty00 On the local side: ifconfig sl0 inet netmask On the remote side: ifconfig sl0 inet netmask
Messages indicating that the specified interface is not configured or created, the requested address is unknown, or that the user is not privi- leged but tried to alter an interface's configuration.
netstat(1), daemon(3), netintro(4), sl(4), ifconfig(8), rc(8), sliplogin(8), slstats(8)
The slattach command appeared in 4.3BSD.
There is no way to specify the interface name (sl%d etc.) to be attached by the slattach command. There is no way to see which interface is assigned to the specified tty by the slattach command, either. It would be better if the network interfaces were created by the slattach command rather than by using the ifconfig(8) create subcommand before the slattach command. NetBSD 10.0 January 18, 2020 NetBSD 10.0
Powered by man-cgi (2024-03-20). Maintained for NetBSD by Kimmo Suominen. Based on man-cgi by Panagiotis Christias.