adm1026hm(4) - NetBSD Manual Pages

ADM1026HM(4)            NetBSD Kernel Interfaces Manual           ADM1026HM(4)


NAME
adm1026hm -- Analog Devices ADM1026 complete thermal system management controller
SYNOPSIS
adm1026hm* at iic0 addr 0x2e: ADM1026 hardware monitor: rev. 0x4, step. 0x5 adm1026hm*: 8 fans, 3 temperatures, 15 voltages
DESCRIPTION
The adm1026hm driver provides support for the Analog Devices ADM1026 hardware monitor. The chip possesses 8 fan speed sensors, 3 temperature sensors, and 17 voltage sensors. The number of each sensor type config- ured by the driver depends on the chip configuration. The values of the sensors are made available through the envstat(8) interface. Sensor Units Description fan N RPM Fan 0-7 internal C Internal temperature external N C External temperature 1-2 Vbatt mV DC Battery voltage V3.3 standby mV DC 3.3V standby voltage V3.3 main mV DC 3.3V main voltage V5.0 mV DC 5.0V supply voltage V+12 mV DC +12V supply voltage V-12 mV DC -12V supply voltage V3.3 N mV DC Analog in (3.3V reference) 0-5 V2.5 N mV DC Analog in (2.5V reference) 0-3
SEE ALSO
iic(4), intro(4), envstat(8)
AUTHORS
The adm1026hm driver was written by Julian Coleman <jcoleman@NetBSD.org>.
BUGS
It's not possible to determine if either a sensor is not connected, or the monitored device is producing no output. Therefore, unconnected sen- sors will show outputs of 0. The adm1026hm driver does not support checking or altering limit values, interrupt output, nor the built-in EEPROM. NetBSD 10.0 December 11, 2015 NetBSD 10.0

Powered by man-cgi (2024-08-26). Maintained for NetBSD by Kimmo Suominen. Based on man-cgi by Panagiotis Christias.