blocklistctl(8) - NetBSD Manual Pages

BLOCKLISTCTL(8)         NetBSD System Manager's Manual         BLOCKLISTCTL(8)


NAME
blocklistctl -- display and change the state of blocklistd
SYNOPSIS
blocklistctl dump [-abdnrw]
DESCRIPTION
blocklistctl is a program used to display the state of blocklistd(8) The following options are available: -a Show all database entries, by default it shows only the embryonic ones. -b Show only the blocked entries. -d Increase debugging level. -n Don't display a header. -r Show the remaining blocked time instead of the last activity time. -w Normally the width of addresses is good for IPv4, the -w flag, makes the display wide enough for IPv6 addresses.
SEE ALSO
blocklistd(8)
NOTES
Sometimes the reported number of failed attempts can exceed the number of attempts that blocklistd(8) is configured to block. This can happen either because the rule has been removed manually, or because there were more attempts in flight while the rule block was being added. This con- dition is normal; in that case blocklistd(8) will first attempt to remove the existing rule, and then it will re-add it to make sure that there is only one rule active.
HISTORY
blocklistctl first appeared in NetBSD 7. FreeBSD support for blocklistctl was implemented in FreeBSD 11.
AUTHORS
Christos Zoulas NetBSD 10.0 June 7, 2016 NetBSD 10.0

Powered by man-cgi (2024-08-26). Maintained for NetBSD by Kimmo Suominen. Based on man-cgi by Panagiotis Christias.