- NetBSD Manual Pages
ESP(4) NetBSD Kernel Interfaces Manual ESP(4)
Powered by man-cgi (2020-09-24).
Maintained for NetBSD
by Kimmo Suominen.
Based on man-cgi by Panagiotis Christias.
esp -- NCR 53C9x, Emulex ESP406, and Qlogic FAS408 SCSI driver
esp0 at isa? port 0x230 irq ?
esp* at pcmcia? function ?
esp* at mca? slot ?
esp0 at obio?
esp1 at obio?
esp0 at obio0 flags 0x00ff
esp0 at obio0 addr 0x66000000 ipl 2 flags 0xff0f
dma0 at obio0 addr 0xfa001000 level 4 (Sun 4/300)
esp0 at obio0 addr 0xfa000000 level 4 (Sun 4/300)
dma0 at sbus0 slot ? offset ? (sun4c and sun4m)
esp0 at sbus0 slot ? offset ? (sun4c)
esp0 at dma0 (sun4m)
dma* at sbus? slot ? offset ? (Sbus)
esp* at sbus? slot ? offset ? (SBus, older PROMs)
esp* at dma? (SBus)
scsibus* at esp?
The esp driver provides support for the NCR 53C90, 53C94 and 53C96;
Emulex ESP100, ESP100A, ESP200 and ESP406; and Qlogic FAS216 and FAS408
SCSI controller chips found in a wide variety of systems and peripheral
boards. This includes the Qlogic ISA and VLB SCSI host adapters, and the
Sun Fast SCSI buffered Ethernet for Sbus (FSBE/S, X1053A, Sun part #
For Qlogic PCI SCSI host adapters, use the isp(4) device.
The esp driver supports the following flags for use in config(1) files:
bits 0-7: disable disconnect/reselect for the corresponding SCSI tar-
bits 8-15: disable synchronous negotiation for the corresponding SCSI
bits 16-23: disable tagged queuing for the corresponding SCSI target
"Target" is synonymous with SCSI ID number.
Note that SCSI tape drives should be allowed to perform disconnect/rese-
lect or performance will suffer.
cd(4), ch(4), intro(4), le(4), mca(4), pcmcia(4), scsi(4), sd(4), ss(4),
NetBSD 9.99 December 3, 2001 NetBSD 9.99