lmenv(4) - NetBSD Manual Pages

Command:
Section:
Arch:
Collection:
>>>
LMENV(4)                NetBSD Kernel Interfaces Manual               LMENV(4)


NAME

     lmenv -- National Semiconductor LM81, LM87, and compatible hardware moni-
     tors


SYNOPSIS

     lmenv0 at iic0 addr 0x2c: ADM9240 rev 2


DESCRIPTION

     The lmenv driver provides support for the National Semiconductor LM87,
     National Semiconductor LM81, Analog Devices ADM9240, and Dallas
     Semiconductor DS1780 iicbus hardware monitors.  Sensor values are
     reported through the envstat(8) interface.

     The lmenv supports the following voltage, temperature, and fan speed sen-
     sors:

           Sensor       Type
           +2.5Vin      Volts DC
           Vccp1        Volts DC
           +Vcc         Volts DC
           +5Vin/Vcc    Volts DC
           +12Vin       Volts DC
           Vccp2        Volts DC
           External     Temperature
           Internal     Temperature
           FAN1         Speed
           FAN2         Speed
     On the LM87 monitor, AIN1 and AIN2 Volts DC sensors may replace either,
     or both of the FAN1 and FAN2 speed sensors, respectively.


SEE ALSO

     envsys(4), envstat(8)


HISTORY

     The lmenv driver first appeared in OpenBSD 3.9.  NetBSD support was added
     in NetBSD 7.0.


AUTHORS

     The lmenv driver was written for OpenBSD by Mark Kettenis
     <kettenis@openbsd.org>, and ported to NetBSD by
     Julian Coleman <jdc@NetBSD.org>.


BUGS

     High and low sensor limits are not supported.

     Interrupt support is not implemented.

NetBSD 10.99                   October 14, 2013                   NetBSD 10.99