- NetBSD Manual Pages
SPLIT(1) NetBSD General Commands Manual SPLIT(1)
Powered by man-cgi (2021-06-01).
Maintained for NetBSD
by Kimmo Suominen.
Based on man-cgi by Panagiotis Christias.
split -- split a file into pieces
split [-a suffix_length] [-b byte_count[k|m] | -l line_count -n
chunk_count] [file [name]]
The split utility reads the given file and breaks it up into files of
1000 lines each. If file is a single dash or absent, split reads from
the standard input. file itself is not altered.
The options are as follows:
-a Use suffix_length letters to form the suffix of the file name.
-b Create smaller files byte_count bytes in length. If `k' is
appended to the number, the file is split into byte_count kilo-
byte pieces. If `m' is appended to the number, the file is split
into byte_count megabyte pieces.
-l Create smaller files line_count lines in length.
-n Split file into chunk_count smaller files.
If additional arguments are specified, the first is used as the name of
the input file which is to be split. If a second additional argument is
specified, it is used as a prefix for the names of the files into which
the file is split. In this case, each file into which the file is split
is named by the prefix followed by a lexically ordered suffix using
suffix_length characters in the range ``a-z''. If -a is not specified,
two letters are used as the suffix.
If the name argument is not specified, `x' is used.
The split utility conforms to IEEE Std 1003.1-2001 (``POSIX.1'').
A split command appeared in Version 6 AT&T UNIX.
The -a option was introduced in NetBSD 2.0. Before that, if name was not
specified, split would vary the first letter of the filename to increase
the number of possible output files. The -a option makes this unneces-
NetBSD 9.2 May 28, 2007 NetBSD 9.2