spi(4) - NetBSD Manual Pages

Command:
Section:
Arch:
Collection:
>>>
SPI(4)                  NetBSD Kernel Interfaces Manual                 SPI(4)


NAME

     spi -- introduction to machine-independent SPI bus support and drivers


SYNOPSIS

     spi* at mainbus?

     Other attachments are machine-dependent and will depend on the bus topol-
     ogy of your system.  See intro(4) for your system for more information.


DESCRIPTION

     NetBSD includes a machine dependent SPI (Serial Peripheral Interface) bus
     subsystem, and several different machine-independent SPI device drivers.

     Your system may support additional machine-dependent SPI devices.  Con-
     sult your system's intro(4) for additional information.

     SPI is a 4-wire synchronous full-duplex serial bus.  Some systems provide
     support for Microwire, which is Philips' name for a strict subset of SPI,
     with more rigidly defined signaling.  Therefore, Microwire devices are
     also supported by the SPI framework.

     Note that when referencing SPI devices in a config(1) file, the `slave'
     must be provided, as SPI lacks any way to automatically probe devices.


HARDWARE

     NetBSD includes the following machine-independent SPI drivers

           m25p       STMicroelectronics M25P family of NOR flash devices.

           tm121temp  Texas Instruments TMP121 temperature sensor.


SEE ALSO

     m25p(4), tm121temp(4)


HISTORY

     The machine-independent SPI framework was written by Garrett D'Amore for
     the Champaign-Urbana Community Wireless Network Project (CUWiN), and
     appeared in NetBSD 4.0.

NetBSD 7.1.1                    October 9, 2006                   NetBSD 7.1.1