fpa(4) - NetBSD Manual Pages

FPA(4)                  NetBSD Kernel Interfaces Manual                 FPA(4)


NAME
fpa, fea, fta -- DEC FDDI interface driver
SYNOPSIS
fpa* at pci? dev ? function ? fea* at eisa? slot ? alpha and pmax fta* at tc? slot ? offset ?
DESCRIPTION
Cards supported by the fpa, fea and fta device driver are: DEFPA DEC PCI FDDI Controller DEFEA DEC EISA FDDI Controller DEFTA DEC TURBOchannel FDDI Controller respectively. All variants of either controller are supported including the DAS and SAS configurations.
DIAGNOSTICS
fea%d: error: desired IRQ of %d does not match device's actual IRQ (%d) The device probe detected that the DEFEA board is configured for a dif- ferent interrupt than the one specified in the kernel configuration file. fea%d: error: memory not enabled! ECU reconfiguration required The device probe found that no device memory had been configured on the DEFEA. The DEFEA can be configured with no device memory, this driver requires a minimum of 1K device memory be set up. The ECU (EISA Configu- ration Utility) will need to be run to change the settings.
SEE ALSO
arp(4), netintro(4), ifconfig(8)
AUTHORS
The fpa, fea and fta device driver and manual page were written by Matt Thomas.
BUGS
Normally, the device driver will not enable the reception of SMT frames. However if the IFF_LINK1 flag is set, the device driver will enable the reception of SMT frames and pass them up to the Berkeley Packet Filter for processing. NetBSD 7.0 March 13, 1995 NetBSD 7.0

Powered by man-cgi (2024-08-26). Maintained for NetBSD by Kimmo Suominen. Based on man-cgi by Panagiotis Christias.