eshconfig(8)
- NetBSD Manual Pages
ESHCONFIG(8) NetBSD System Manager's Manual ESHCONFIG(8)
NAME
eshconfig -- configure Essential Communications' HIPPI network interface
SYNOPSIS
eshconfig [-estx] [-b bytes] [-c bytes] [-d filename] [-i usecs]
[-m bytes] [-r bytes] [-u filename] [-w bytes] [interface]
DESCRIPTION
eshconfig is used to configure device-specific parameters and download
new firmware to the Essential Communications RoadRunner-based HIPPI net-
work interface. The interface is very sensitive to the DMA performance
characteristics of the host, and so requires careful tuning to achieve
reasonable performance. In addition, firmware is likely to change fre-
quently, which necessitates a reasonably easy way to update that
firmware.
Available operands for eshconfig:
-b bytes
Adjust the burst size for read (by NIC of host memory) DMA.
-c bytes
Adjust the burst size for write (by NIC of host memory) DMA.
-d filename
Filename for file to download into NIC firmware. This must be a
file in the standard Essential format, with :04 preceding every
line, and a tag line at the end indicating the characteristics of
the firmware file.
-e Write data to EEPROM. Normally, setting tuning parameters will
only persist until the system is rebooted. Setting this parame-
ter ensures that the changes will be written to EEPROM.
-i usecs
Interrupt delay in microseconds.
-m bytes
Minimum number of bytes to DMA in one direction (read or write)
before allowing a DMA in the other direction. Tuning this pre-
vents one direction from dominating the flow of bytes, and arti-
ficially throttling the NIC.
-r bytes
Bytes before DMA starts for read (from host to NIC). This con-
trols how soon the DMA is triggered; until this many bytes are
requested, the DMA will not begin.
-s Show statistics for the HIPPI NIC. Repeat the option to suppress
non-zero statistics.
-t Show current tuning parameters on the host.
-u filename
Name of file to which the NIC firmware should be uploaded. Not
currently supported.
-w bytes
Number of bytes required before write (from NIC to host) DMA is
started. Until this many bytes are ready to be written, the DMA
will not start.
-x Reset the NIC. This is necessary for the HIPPI-FP support, as
ifconfig(8) will no longer physically reset the NIC when the
interfaces goes up and down.
Only the super-user may modify the configuration of a network interface.
DIAGNOSTICS
Messages indicating the specified interface does not exist or the user is
not privileged and tried to alter an interface's configuration.
SEE ALSO
esh(4), ifconfig(8)
HISTORY
The eshconfig command first appeared in NetBSD 1.4.
NetBSD 6.0.3 June 17, 2005 NetBSD 6.0.3
Powered by man-cgi (2024-08-24).
Maintained for NetBSD
by Kimmo Suominen.
Based on man-cgi by Panagiotis Christias.