isv(4) - NetBSD Manual Pages

isv(4)                  NetBSD Kernel Interfaces Manual                 isv(4)


NAME
isv -- IDEC Supervision/16 image capture board
SYNOPSIS
isv0 at isa? port 0x2f0 isv0 at isa? port 0x2e0 isv0 at isa? port 0x3f0 isv0 at isa? port 0x3e0
DESCRIPTION
isv is a driver for the IDEC Supervision/16, an image capture board that plugs into a 16-bit ISA bus. The IDEC Supervision/16 digitizes an NTSC television signal, storing a 512 x 480-pixel, 8-bit grayscale image in its 256kB dynamic RAM array every 1/30th of a second. The host reads frames from the DRAM using 122881 16-bit I/O reads. Reading frames from the Supervision/16 is quite slow: after the host reads a 16-bit word from the DRAM, the Supervision/16 state machine takes approximately 0.5 microseconds to get ready for the next read. Theoretically, a frame rate of approximately 10 frames per second is possible. isv achieves a frame rate of approximately 6 frames per second.
SEE ALSO
isvctl(8) Programming the Supervision/16 Image Capture Board, IDEC, circa 1991.
HISTORY
The isv device first appeared in NetBSD 5.0.
AUTHORS
The isv driver was written by David Young <dyoung@NetBSD.org>.
BUGS
Synchronizing with the hardware and reading frames from it is very CPU- intensive. isv will not detect the capture board if it is not attached to an active video source. To force NetBSD to detect the capture board at any time, re-scan the ISA bus using, e.g., drvctl -r isa0. NetBSD 5.0 April 1, 2008 NetBSD 5.0

Powered by man-cgi (2024-08-26). Maintained for NetBSD by Kimmo Suominen. Based on man-cgi by Panagiotis Christias.