xge(4) - NetBSD Manual Pages

XGE(4)                  NetBSD Kernel Interfaces Manual                 XGE(4)


NAME
xge -- Neterion Xframe-I Ten Gigabit Ethernet driver
SYNOPSIS
xge* at pci? dev ? function ?
DESCRIPTION
The xge device driver supports the Neterion Xframe-I LR Ethernet adapter, which uses a single mode fiber (1310nm) interface. The Xframe supports IPv4/TCP/UDP checksumming in hardware, as well as TCP Segmentation Offloading (TSO) and hardvare VLAN handling. The driver does currently not support the hardware VLAN feature. See ifconfig(8) for information on how to enable TSO and hardware checksum calculation.
DIAGNOSTICS
xge%s: failed configuring endian, %llx != %llx! The Xframe could not be turned into the correct endian operation. This is most likely a hardware error. xge%d: failed allocating txmem. xge%d: failed allocating rxmem. The computer has run out of kernel mem- ory. xge%d: adapter not quiescent, aborting xge%d: ADAPTER_STATUS missing bits %s The Xframe could not be turned into a useable state. Most likely a Xframe hardware error. xge%d: cannot create TX DMA maps xge%d: cannot create RX DMA maps This error is either a kernel error or that the kernel has run out of available memory. xge%d: bad compiler struct alignment, %d != %d The compiler did not align the structure correctly. This is a compiler problem.
SEE ALSO
arp(4), ifmedia(4), netintro(4), pci(4), ifconfig(8)
HISTORY
The xge driver first appeared in NetBSD 3.0.
AUTHORS
The xge driver was written by Anders Magnusson <ragge@ludd.luth.se>.
BUGS
There should be an XGMII framework for the driver to use. NetBSD 3.0 September 9, 2005 NetBSD 3.0

Powered by man-cgi (2024-08-26). Maintained for NetBSD by Kimmo Suominen. Based on man-cgi by Panagiotis Christias.