viaide(4) - NetBSD Manual Pages

VIAIDE(4)               NetBSD Kernel Interfaces Manual              VIAIDE(4)


NAME
viaide -- AMD, NVIDIA and VIA IDE disk controllers driver
SYNOPSIS
viaide* at pci? dev ? function ? flags 0x0000 options PCIIDE_AMD756_ENABLEDMA
DESCRIPTION
The viaide driver supports the following IDE controllers and provides the interface with the hardware for the ata driver: - Advanced Micro Devices AMD-756, 766, and 768 IDE Controllers - NVIDIA nForce, nForce2, nForce2 400, nForce3, nForce3 250, and nForce4 IDE Controllers - VIA Technologies VT82C586, VT82C586A, VT82C596A, VT82C686A, VT8233A, VT8235 and VT8237 IDE Controllers, and VT6421 Serial RAID Controller The 0x0002 flag forces the viaide driver to disable DMA on chipsets for which DMA would normally be enabled. This can be used as a debugging aid, or to work around problems where the IDE controller is wired up to the system incorrectly.
SEE ALSO
ata(4), atapi(4), intro(4), pci(4), pciide(4), wd(4), wdc(4)
NOTES
Drives on the VT6421 Serial RAID Controller can only be accessed after they have been configured into RAID or JBOD sets via its BIOS. It is also inaptly named as it has both SATA and PATA interfaces.
BUGS
The AMD756 chip revision D2 has a bug affecting DMA (but not Ultra-DMA) modes. The workaround documented by AMD is to not use DMA on any drive which does not support Ultra-DMA modes. This does not appear to be nec- essary on all drives, the PCIIDE_AMD756_ENABLEDMA option can be used to force multiword DMA on the buggy revisions. Multiword DMA can eventually be disabled on a per-drive basis with config flags, see wd(4). The bug, if triggered, will cause a total system hang. The timings used for the PIO and DMA modes for controllers listed above are for a PCI bus running at 30 or 33 MHz. This driver may not work properly on overclocked systems. NetBSD 3.0.1 February 2, 2005 NetBSD 3.0.1

Powered by man-cgi (2024-08-26). Maintained for NetBSD by Kimmo Suominen. Based on man-cgi by Panagiotis Christias.