ldpd.conf(5) - NetBSD Manual Pages

Command:
Section:
Arch:
Collection:
>>>
LDPD.CONF(5)              NetBSD File Formats Manual              LDPD.CONF(5)


NAME

     ldpd.conf -- ldpd configuration file


SYNOPSIS

     ldpd.conf


DESCRIPTION

     The ldpd.conf file defines the ldpd(8) initial setup and may contain
     information about LDP identificator, network, neighbour and interface
     parameters.  Blank lines are allowed and comments lines should start with
     `#'.  Non block lines should end with a semicolon.


FILES

     /etc/ldpd.conf  The file ldpd.conf resides in /etc.


CONFIGURATION

     The following options are accepted:

     command-port    Control and command TCP port (default: 2626)

     hello-time      Interval in seconds on which hellos are sent out on
                     interfaces (default: 6s)

     interface       Interface block commands (see below)

     keepalive-time  Keepalive interval in seconds for established peers
                     (default: 4s)

     ldp-id          Force using a certain LDP Identificator (default autogen-
                     erated, highest INET4 address set on an interface exclud-
                     ing 127/8 range)

     min-label       Minimum number used for generated labels (default: 16)

     max-label       Maximum number used for generated labels (default:
                     1048576)

     neighbour       Neighbour block subcommands (see below)

     no-default-route
                     If set to 0 ldpd(8) will try to tag also the default
                     route (default: 1)

     Interface block supports the following parameters

     passive            Don't send hellos on interface

     transport-address  Transport INET4 address advertised in hellos sent on
                        the mentioned interface

     Neighbour block supports the following parameters

     authenticate  Authenticate peer using TCP MD5 signature - needs options
                   TCP_SIGNATURE.  Default: off


EXAMPLES

     The following is an example /etc/ldpd.conf file:

     # Transport address needs to be an alias for this interface
     interface re0 {
             transport-address 192.168.2.2
     }

     # Don't send hellos on en0
     interface en0 {
             passive
     }

     # Force a certain LDP ID
     ldp-id 10.5.1.1;

     # Tag also the default route
     no-default-route 0;

     neighbour 192.168.2.1 {
     # TCP MD5 authentication - requires options TCP_SIGNATURE
             authenticate
     }


SEE ALSO

     mpls(4), ldpd(8)


HISTORY

     Support for ldpd.conf first appeared in NetBSD 6.0.

NetBSD 10.1                    October 18, 2013                    NetBSD 10.1