tl(4) - NetBSD Manual Pages

Command:
Section:
Arch:
Collection:
>>>
TL(4)                   NetBSD Kernel Interfaces Manual                  TL(4)


NAME

     tl -- Ethernet driver for Texas Instruments ThunderLAN based board


SYNOPSIS

     tl* at pci? dev ? function ?

     Configuration of PHYs is necessary.  See mii(4).


DESCRIPTION

     The tl device driver supports network adapters based on the Texas Instru-
     ments ThunderLAN chip.


HARDWARE

     Supported cards include:

           Compaq Netelligent
                   in baseboard and PCI variants (10BASE-T-only variant
                   untested).

           Compaq NetFlex 3/P
                   in baseboard variant only (the PCI variant doesn't use the
                   same chip!).

           It Baseboard Compaq Deskpro 4000 5233MMX Ethernet
                   (This has been tested on the Deskpro 4000M only).

           TI TravelMate 5000 series laptop docking station's Ethernet board.


MEDIA SELECTION

     The different models of the supported boards come with some subset of
     RJ-45, BNC and AUI connectors.  Media selection is done using ifconfig(8)
     using the standard ifmedia(4) mechanism.  Refer to those manual pages for
     more information.

     The tl driver doesn't have full automatic media selection.  By default it
     will do an Nway (IEEE 802.3u) negotiation on the 10BASE-T port for the
     speed and duplex mode with the link partner.  If the AUI or BNC port is
     used, an explicit media type must be specified to ifconfig(8).


SEE ALSO

     ifmedia(4), mii(4), netintro(4), pci(4), ifconfig(8)


BUGS

     The board marked as untested will always claim having an AUI connector,
     where it may be a BNC one.

NetBSD 10.1                      May 16, 2009                      NetBSD 10.1