fea(4) - NetBSD Manual Pages

Command: Section: Arch: Collection:  
FPA(4)                    NetBSD Programmer's Manual                    FPA(4)

fpa, fea, fta - DEC FDDI interface driver
fpa* at pci? dev ? function ? fea* at eisa? slot ? alpha and pmax fta* at tc? slot ? offset ?
Cards supported by the fpa, fea and fta device driver are: DEFPA DEC PCI FDDI Controller DEFEA DEC EISA FDDI Controller DEFTA DEC TURBOchannel FDDI Controller respectively. All variants of either controller are supported including the DAS and SAS configurations.
fea%d: error: desired IRQ of %d does not match device's actual IRQ (%d) The device probe detected that the DEFEA board is configured for a different interrupt than the one specified in the kernel configuration file. fea%d: error: memory not enabled! ECU reconfiguration required The de- vice probe found that no device memory had been configured on the DEFEA. The DEFEA can be configured with no device memory, this driver requires a minimum of 1K device memory be setup. The ECU (EISA Configuration Utili- ty) will need to be run to change the settings.
arp(4), netintro(4), ifconfig(8)
The fpa, fea and fta device driver and manual page was written by Matt Thomas.
Normally, the device driver will not enable the reception of SMT frames. However if the IFF_LINK1 flag is set, the device driver will enable the reception of SMT frames and pass them up to the Berkeley Packet Filter for processing. NetBSD 1.6.2 March 13, 1995 1
Powered by man-cgi (2024-03-20). Maintained for NetBSD by Kimmo Suominen. Based on man-cgi by Panagiotis Christias.